Once you've decided to purchase an iPod car kit, inevitably you've chosen the Gateway Lite produced by Dension. You only have one further obstacle to hurdle, the installation. There are two options available to you for installing the kit. The first option, Pay a professional engineer to install the kit, either travelling to them or they can travel to you. The second option, is to install the iPod car kit yourself. Which is by far the more cost effective option and probably most convenient too. See below an installation guide to judge whether your capable of the installation, should you choose to go ahead.
The installation of the Gateway lite is fairly simple and pain free. Although this is a generic installation guide, it will suit 99% of vehicles.
Before you begin the installation, please remove the keys from the ignition and check that any radio codes are recorded for future reference.
Step one is to remove your car stereo, this will usually involve radio removal tools which will vary depending on what vehicle you have. Radio removal keys are readily available and the majority of online shops or traditional vehicle based retail outlets stock them. Radio removal tools are extremely convenient and can save you a lot of time and energy. This should take between 1-5 minutes
Step two is to remove the harnesses from the back of the stereo, Most vehicles have a Quadlock connection, this is a fairly large connection block that houses the wires to and from the stereo. If the Harness is a Quadlock connection the Dension harness will usually replicate the original harness exactly. The Dension Lite harness simply fits into the vehicle harness and then back to the stereo, basically a link between the vehicle and the stereo.
If the vehicle doesn't have a Quadlock connection, the gateway lite harness fits into the CD changer port on the the back of the stereo. Usually located in the top right of the stereo as your looking at the back of it. Most of the time the harness simply connects straight into place, however occasionally the harness may have to be connected into the original harness then re-connected. This stage should take 2 minutes.
Step three is to connect the Gateway Lite PCB (the little black box) to the dension harness, its the most straight forward step of the installation. This will take 30 seconds.
Step Four is to connect the iPod dock and USB extension cable to the PCB, again very straight forward. Once this stage is done its usually a good idea to turn ignition on to check the system works. (Follow the user manual to perform the operations for iPod/USB track selection) Again this will take 1-2 minutes.
Step five, Route the cables through into position within the vehicle, this is usually the most time consuming part of the installation. Depending on the vehicle this can be a complex job and may require the removal of some of the fascia / Dashboard. This part of the installation may take up to 30 minutes depending on difficulty, especially if you want a professionally installed look.
Step Six, replace the stereo into its fittings. Read the operational instructions from Dension and enjoy the use of your iPod and all of your music while your driving.
Get a fully integrated iPod car kit in your vehicle, the installation is simple pain free, There's no need for cheap Fm Transmitters when fully integrated iPod car adapter are available. View the Dension Gateway Lite for your vehicle.
No comments:
Post a Comment